Help with Hacker X-5 to Hacker A10-15s
05-29-2011, 03:02 PM
#1
Member
Thread Starter
Join Date: Nov 2010
Posts: 20
Help with Hacker X-5 to Hacker A10-15s
Hello all, I am a newb to flying foamies, and electric in general. I bought a whole lot of stuff and sold most of it off. I have a foamie left that I would like to fly, but I need to put the Motor and ESC back on. The problem is that the previous owner unsoldered the leads from the ESC that goes to the motor, and I dont know which order to solder them back on. Any help would be greatly appreciated. Thanks! The Motor is a Hacker A10-5s, The ESC is Hacker X-5
05-30-2011, 02:59 AM
#2
Gravity is Attractive
Join Date: Aug 2005
Location: ALLIANCE, OHIO
Posts: 183
Connect the three wires from the ESC to any of the three wires on the motor, If the motor runs the wrong direction simply swap any two of the wires between the motor and the esc and that will reverse the rotation
Roger aka GIFLYRC
Roger aka GIFLYRC
05-30-2011, 05:45 AM
#3
Super Contributor
Join Date: Apr 2008
Location: Wisconsin, USA
Posts: 8,952
Originally Posted by flyingbumma
Hello all, I am a newb to flying foamies, and electric in general. I bought a whole lot of stuff and sold most of it off. I have a foamie left that I would like to fly, but I need to put the Motor and ESC back on. The problem is that the previous owner unsoldered the leads from the ESC that goes to the motor, and I dont know which order to solder them back on. Any help would be greatly appreciated. Thanks! The Motor is a Hacker A10-5s, The ESC is Hacker X-5
I've used duct tape or similar. Even used electrical "Wire Nuts" more than once for temporary connection of those motor wires.
Thread
Thread Starter
Forum
Replies
Last Post
kyleservicetech
Power Systems
29
01-05-2012 01:40 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
