Brushless Motor Construction Discuss design and construction of custom Brushless motors

detrum bm2815a-kv 1100

Old 03-02-2012, 09:49 PM
New Member
Thread Starter
Join Date: Jan 2012
Posts: 17
Default detrum bm2815a-kv 1100

detrum bm2815a-kv 1100 Im trying to find specs on the motor and cant find them any anywhere. Broke the shaft off and hopefully can just replace the shaft but dont know what size it is. Hasnt even had a maiden flight on it just taxied it into a wall. I cant get the shaft out its almost like its pressed into the housing took out the set screw and the c-clip and it wont budge, any suggestions. There is a little shaft left just wondering if I could put a spinner collet onto it but i dont know the saft size and its hard to measure 3.5 mm or 4mm

Last edited by golfryan; 03-02-2012 at 10:17 PM.
golfryan is offline  
Old 06-22-2012, 05:21 AM
New Member
Join Date: Jun 2012
Posts: 1
Default dynam motor replacement and both stock the dynam motor. also stocks JUST the shaft. the shaft IS pressed into the motor housing VERY tightly, but may be hammered out if you take care. I HAVE replaced mine ... lightly tap out, lightly tap in ... no problem really.
waynebyerlyjr is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.09893 seconds with 14 queries