WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - JR X9503 Get into Service access menu HELP needed
Old 05-08-2019, 04:16 AM
  #6  
Jools
Member
 
Jools's Avatar
 
Join Date: Mar 2019
Posts: 23
Default

I'm getting there!
I now have all main functions ok for mode 1.
I've got elevator trim now (which was the hitch earlier), by programming in elevator and flap, -but don't have/need flaps. But I get elevator trim on the 3 pos switch top panel left side labelled F-MODE AUX 4. It's only one step up, neutral, and one step down, but that's good enough (Obviously I can re-program the amount of the steps and total trim travel later after test flights). I have a 1 second delay on 'Flap sys' that brings the elev trim in gradually and smoothly. I'll now see if I can program another mix using one of the side rotary levers to give a completely graduated elev trim action.
Jools is offline  
 
Page generated in 0.03006 seconds with 10 queries