View Single Post
Old 01-28-2006, 06:31 PM
zappedalaskan's Avatar
Join Date: Aug 2005
Location: Fairbanks Alaska
Posts: 841

Hi Guys,
Your blades are just a bit loose, they should move easily but not quite where they will fall over when you set the heli on it's side.
Is the whole main shaft moving in the main shaft bearings? Your main shaft should be solid. You need to look while wiggling it around and see if the bearings are moving as well our if the shaft is moving in the bearings. You might try tightening the screws that attach the bearing blocks to the main frame and see if that fixes it. That play probably had a lot to do with your blade strike you had. If the shaft is wiggling in the bearings you need to replace the shaft or the bearings. I hope this helps
Happy hovering,
zappedalaskan is offline  
Page generated in 0.04156 seconds with 8 queries