View Single Post
Old 11-25-2020, 05:12 AM
New Member
Join Date: Nov 2020
Posts: 5

Tried to bind my Flysky FS-iA6B receiver to my TX18S radio tonight.
Receiver uses AFHDS 2A protocol.

Set internal RF to MULTI Flysky 2A, PWM SBUS as shown in you tube video. Receiver LED flashes rapidly in binding mode.
Once I select bind on my radio the screen says binding and the radio beeps but will not bind to the receiver.

Still frustrated why it works on other radios with open tx but not mine.

Is being too close to your radio or interference from computer, wifi, etc. inside house a real concern.

Do I need to go outside to bind?

Any suggestions would be greatly appreciated.

wbs1979 is offline  
Page generated in 0.06473 seconds with 8 queries