WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Everything You Wanted To Know About Electric Powered Flight
Old 08-28-2008, 08:12 PM
Community Moderator
Join Date: Aug 2005
Location: NY, USA
Posts: 5,839


Manufacturers use different wire winds to produce different Kv results.

Kv is a number that relates to how many RPMs a given motor will spin based
on applied voltage. You will see specs on motors where it says Kv=860.
That means that the motor will spin at 860 rpms if you apply one volt to it.
If you apply 7 volts it will span at 6020 rpms.

If the manufacturer takes the same motor he can wind it so that it will
have a lower Kv rating, which typically produces more torque, so these are
typically used with large propellers that will be turned slower. These are
very popular on gliders, for example, where climb angle and climb rate is
much more important than top speed.

Take the same motor and wind it differently and it will have a higher Kv
rating producing higher speeds for a given voltage. These are typically
used with smaller props for higher top speeds. Or they can be used with gear
boxes to handle those big props, providing a similar result to low KV
motors. Sometimes a gear box works better in the installation.

You would also take KV into consideration based on what battery you plan to

If you look here you will see that a given motor is offered in several Kv
ratings. They make suggestions as to which motor is best matched with which
prop and which battery packs. If you click on a given motor you can see what
kinds of power is drawn based on which pack and which prop. If you click on
each of the motors within a model you can see the very different power
curves produced by the different battery/prop combos. Here you see the same
motor with a different wind producing a different Kv result, each optimized
for a different purpose.

So, how does this add to other information about motors?

I first set a watts/pound target for my plane depending on the performance I
want. I typically target between 70 and 100 watts per pound for sport
planes and gliders. I don't fly 3D.

Then I consider whether I am looking for high speed or high climb rate. A
glider or a 3D plane would be optimized more toward the climb rate side of
this discussion. A pylon racer would be optimized more for speed. A pattern
plane might be somewhere in the middle.

Now I get down to prop and battery. Wider prop for better climb, narrower
deeper prop for higher speed. Now look at the motor character based on
either battery target or prop target and choose the motor/battery/prop combo
that meets your objectives.

That is kind of high level but you get the idea.
AEAJR is offline  
Page generated in 0.09147 seconds with 8 queries