View Single Post
Old 08-29-2021, 01:06 PM
  #1  
The Professor
Professional Nerd
 
The Professor's Avatar
 
Join Date: Jun 2021
Location: West Yorkshire
Posts: 26
Default Antenna mounting

When mounting the receiver, the destructions specify the antennae need to be 90, the antenna is covered in heat shrink, with a wider section approx 7mm diameter.Is the wider section the entire antenna, or is that a base coil with a further piece of wire extending up the inside of the heat shrink?

I ask as I cannot fit the full heat shrink length inside my plane at 90

Last edited by The Professor; 08-29-2021 at 01:07 PM. Reason: Adding a picture (hopefully)
The Professor is offline  
 
Page generated in 0.04949 seconds with 7 queries