View Single Post
Old 06-09-2021, 09:54 PM
  #7  
E-Challenged
Member
 
E-Challenged's Avatar
 
Join Date: Aug 2005
Location: Southern CA
Posts: 568
Default

There is a long running thread all about the Dynam WACO on RC Groups Parkflyers forum. To access motor mount screws, remove the ring cowl. Cowl may be "stuck" in place and take some effort to remove. Once cowl is removed, you have access to the motor mount screws and can replace motor if need be. While you have cowl off, you can cut some grooves in firewall area to let hot air exhaust. Motor can get quite hot on hot days with full throttle and melt plastic motor mount. Not sure what to do with tailwheel problem short of possible foam surgery to get at and fix problem or adding a new steerable tail wheel assembly and connection to rudder.

I have been flying my Dynam Waco for 4 years, it's worn out but still flies great, is very aerobatic.

Last edited by E-Challenged; 06-10-2021 at 05:56 PM.
E-Challenged is offline  
 
Page generated in 0.06647 seconds with 8 queries