Old 04-29-2015, 08:50 AM
  #3  
CHELLIE
Super Contributor
 
CHELLIE's Avatar
 
Join Date: Oct 2006
Location: Hesperia, So. Calif
Posts: 19,269
Default

Hope This Helps the top blade holder might be turning on the shaft, that happens after a crash, check the main shaft, make sure it not bent, check the gear mesh, make sure it did not tighten up, adjust if needed with a piece of paper between the gears, there should be a little gear slop. the videos below will give you other possible things to check for.

https://www.youtube.com/watch?v=w5H3RNLaOtE

https://www.youtube.com/watch?v=R65JJYwSH50

https://www.youtube.com/watch?v=-Czz0tXmVig
CHELLIE is offline  
 
Page generated in 0.06520 seconds with 10 queries