View Single Post
Old 08-04-2021, 12:14 PM
New Member
Join Date: Aug 2021
Posts: 7

So i connected the throttle to CH 6 instead of 3 that it was in, Still same problem except that the throttle obviously didnt work since i swapped ports. The rudder didn't turn before about 25% throttle and so on..
Next i connected the throttle to it's correct place as you said and put the rudder on the switch instead, this time the rudder was controlled by the 2 position switch as it should have, and no matter the throttle position it stayed in place as it should

So it seems like CH 3 and 4 has some kind of mix as you said. The controller has always been a bit iffy so i suspect that's the issue
Danni is offline  
Page generated in 0.05811 seconds with 9 queries