View Single Post
Old 08-31-2014, 07:26 AM
New Member
Join Date: Aug 2014
Posts: 7

fhhuber, yeah i searched for the longest time for a suitable unit both in terms of blade-count and strength... i suspect that the unit available at HK will not be able to handle the 700 or so W.

This may be an option:

It's probably not the highest quality, but certainly pushes it into the realm of affordable experimentation. piper92, i think in your previous post you were explaining a method of locking down the degrees of freedom of the rotor head but i'm not sure i understand.

is there maybe an aftermarket tail rotor part that I could adapt to the axel in the above listed piece in lieu of a multi-DOF swash plate? that may be the simplest option.
njherr is offline  
Page generated in 0.05984 seconds with 10 queries