View Single Post
Old 01-27-2013, 08:44 PM
  #54  
Nitro Blast
Community Moderator
 
Nitro Blast's Avatar
 
Join Date: Aug 2005
Location: Sunny San Diego Ca
Posts: 4,052
Default

Originally Posted by George8286 View Post
Thanks for the fast reply Nitro-Blast.

With all that said, do you have any recommendations as to wiring for the twin motor set-up? Maybe a diagram!? Like I said we are both new in the electric arena.

Thanks again,
George

What I did was use the factory wires and made positive/negative leads making the Y split at wing center, and go inside through the wing to the nacelles. I put the speed controllers on the motor mount. I made a deans style plug so I can remove the wing.

Batteries, servos and RX in the fuse, but all the power wiring, controllers motors in wing.
Nitro Blast is offline  
 
Page generated in 0.08358 seconds with 8 queries