WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - New to Electric Flight
View Single Post
Old 01-23-2020, 05:13 PM
  #15  
ron_van_sommeren
homo ludens modelisticus
 
ron_van_sommeren's Avatar
 
Join Date: Jul 2005
Location: near Nijmegen, Nederland
Posts: 1,158
Default

Originally Posted by dasintex View Post
... I have over 30 yrs RC experience, mostly Glow and Big Gasser Planes including Twins; a few Small Electric single Motor RTF Planes that didn't need a lot of guesswork ....
No worries then, you already have experience with e-equipment and e-routines.

Originally Posted by dasintex View Post
... Being Canadian ...
Slightly worrisome

Originally Posted by dasintex View Post
.... You posted that I need to cut the red Lead or Pin on one of the ESC's to eliminate conflicting Voltages and/or frequencies depending on the type of BEC; Y-connecting both ESCs leads into single feed into Receiver won't accomplish this? ...
No, it won't. The whole point of an Y cable is to connect the three plus pins in the three connectors, the three minus pins and the three pulse pins.



ron_van_sommeren is offline  
 
Page generated in 0.05005 seconds with 8 queries