WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Looking for a gyro: Simple programming
View Single Post
Old 12-02-2018, 08:33 PM
New Member
Join Date: Nov 2018
Posts: 2
Default Looking for a gyro: Simple programming

JR XG11 Transmitter
Speclktrum AR 636 6 Ch Receiver with AS3X technology
Freewing Avanti S 80mm EDF Ultimate Sport Jet (Motion RC. Just purchased. Have not put together yet)
*I have flown the JR XG11 transmitter with the spektrum AR 636 on a E-Flite Slick 3D but I did not program the AS3X technology, hence, just a regular old reciever. The point being I know the XG11 transmitter will work with the Spektrum receiver.

So here goes.....
I have heard a lot of complaints about the complexity of programming the AS3X technology. Hull losses due to "trial and error" when programming it.
I am not interested in using the new jet as a "test bed" for such a complex programming feat. Too much risk.
I might take a stab at programming the AS3X technology on one of my park flyers (E-Flite Slick 3D/Battle Tested!)

What I am looking for.....
A stability GYRO to put in this jet to help with handling in winds/overall stability
1. Compatible with the setup listed above. Compatibility has always been a big question mark. Needs to work with XG11/Specktrum AR 636 receiver (AS3X technology is turned OFF/Not programmed).
2. Easy to program without major risk of hull loss.

What I "don't know"....
Never had a "gyro" so I am a newbie at this technology. I have heard it really helps though.

jigeye is offline  
Page generated in 0.02870 seconds with 8 queries