View Single Post
Old 09-01-2020, 05:38 PM
  #2  
crxmanpat
Community Moderator
 
crxmanpat's Avatar
 
Join Date: Feb 2006
Location: Mesa, AZ
Posts: 6,898
Default

There is no specific place the Castle UBEC needs to be installed, but you do want it where it will get a little air cooling.

You will need to solder the power leads of the BEC into the battery connection. I think this comes with an EC5 connector, and the pins can be pushed out of the housing (they just snap in). Push the pins out and solder the BEC power leads to them (see example in the pic, the green circuit board is the BEC in this case). You will also need to pull the red wire from the ESC lead to the RX. Take a hobby knife and gently insert under the locking tab in the connector and lift up, then pull the red wire out and secure it with tape. The Castle RX lead then plugs into the RX in the battery/bind port depending on your RX.
Attached Thumbnails Click image for larger version

Name:	freewing-90mm-edf-f-a-18c-hornet-130-amp-brushless-esc-motion-rc-12477227958385_large.jpg
Views:	11
Size:	21.3 KB
ID:	188216  
crxmanpat is offline  
 
Page generated in 0.09700 seconds with 12 queries