View Single Post
Old 02-25-2013, 04:10 PM
  #216  
Gumby77
New Member
 
Join Date: Feb 2013
Posts: 2
Default

Originally Posted by hayofstacks View Post
Drill the inner bolt pattern into the firewall, throw the "x-mount" aside, and make sure your screws are long enough, but not too long to hit windings in the motor. Put a washer or two on the firewall side to keep the screws from pulling though, hit them with ca if you would like.

Or cut the ears off the xmount and put it in there instead of the washers. Most parkflyer sized motors have 3mm motor screws.

That is what I was originally thinking so it's great to hear. I'll post pictures of the workaround.


Thanks
Gumby77 is offline  
 
Page generated in 0.08817 seconds with 10 queries