View Single Post
Old 02-25-2013, 12:49 AM
  #214  
hayofstacks
Super Contributor
 
hayofstacks's Avatar
 
Join Date: Jan 2012
Location: Utah
Posts: 1,780
Default

Drill the inner bolt pattern into the firewall, throw the "x-mount" aside, and make sure your screws are long enough, but not too long to hit windings in the motor. Put a washer or two on the firewall side to keep the screws from pulling though, hit them with ca if you would like.

Or cut the ears off the xmount and put it in there instead of the washers. Most parkflyer sized motors have 3mm motor screws.
hayofstacks is offline  
 
Page generated in 0.06136 seconds with 8 queries