Thread: Mounting Motor
View Single Post
Old 07-15-2021, 01:41 PM
  #2  
solentlife
Super Contributor
 
solentlife's Avatar
 
Join Date: Oct 2010
Location: Ex UK Brit now in Latvia west coast - Ventspils
Posts: 12,791
Default

When I have met this problem - I have created a separate ply plate to glue on the inside of the mount box It only needs to be enough to give more strength to the new holes being so close to the old.
Of course the captive nuts etc. are all removed before epoxying in the plate. If weight is issue - then use PU Glue (Gorilla Glue).

OR

You could remove that box mount and use Stand-Off tube mounts ..... basically threaded tubes that stand the motor of required distance from the rear firewall.
solentlife is offline  
 
Page generated in 0.06482 seconds with 8 queries