Old 01-23-2021, 01:58 PM
  #1  
jb48
Member
 
Join Date: Oct 2005
Location: Quebec, Canada
Posts: 374
Default Trouble with initial calibration of an Avian 60 amp esc

Hi everyone. It's the second day I desperately try to initializing my brand new Avian 60 amp esc. I followed all the instructions, double checking them. When I connect the battery to the esc, throttle at full position before connecting, all I get from the esc is a rapid ascending tones, not followed by the confirming bip bip, but only by single short bip about every second for as long as the esc is connected to the battery. Motor (brand new Power 32) will not run but all control servos respond very well to tx inputs. I am lost! If someone could help me I would greatly appreciate. Thanks in advance.
jb48 is offline  
 
Page generated in 0.07539 seconds with 9 queries