View Single Post
Old 10-15-2020, 06:09 PM
  #4  
solentlife
Super Contributor
 
solentlife's Avatar
 
Join Date: Oct 2010
Location: Ex UK Brit now in Latvia west coast - Ventspils
Posts: 12,596
Default

Having recently changed from my Print-Rite (still in operation ... ) to the Ender 3 Pro ...... I have got used to the magnetic bed. Marvelous bit of kit. But as my pal found out and I did as well ... it soon develops bumps and pits ... in fact mine split few days ago and I had to change to the glass bed. Everyone I know has basically put their glass beds aside and stayed with painters tape on bed or with magnetic.
I went online and they talked about using the same 'adhesive' as I have used with tape on my PR ...... hairspray ....

Works a treat .... heated bed helps it be tacky and hold the print ... once cooled - print just pops off easy.... hand sanitizer then claens bed ready for next job ...
solentlife is offline  
 
Page generated in 0.04368 seconds with 8 queries