WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - How Do I Mount My Outrunner Motor ?
View Single Post
Old 06-09-2009, 07:01 AM
  #78  
Larry G
E-Pilot
 
Join Date: Jul 2007
Location: Peoria, Arizona
Posts: 444
Default

Here is the motor mount I came up with for my GWS-190. I wanted something I could adjust easily in case I wanted to move the motor forward or back for balance. I glued plywood to two sides of the fuselage front "octagon", then screwed on two side panels which in turn screw to a plywood firewall. If I want to move it back any further I will have to trim the side pieces. I was able to hog out the air channels in the foam for better cooling air flow. Plenty of room for the ESC, and the cowl clears fine.


Larry G is offline  
 
Page generated in 0.02833 seconds with 8 queries