View Single Post
Old 01-27-2013, 07:44 PM
Nitro Blast
Community Moderator
Nitro Blast's Avatar
Join Date: Aug 2005
Location: Sunny San Diego Ca
Posts: 4,052

Originally Posted by George8286 View Post
Thanks for the fast reply Nitro-Blast.

With all that said, do you have any recommendations as to wiring for the twin motor set-up? Maybe a diagram!? Like I said we are both new in the electric arena.

Thanks again,

What I did was use the factory wires and made positive/negative leads making the Y split at wing center, and go inside through the wing to the nacelles. I put the speed controllers on the motor mount. I made a deans style plug so I can remove the wing.

Batteries, servos and RX in the fuse, but all the power wiring, controllers motors in wing.
Nitro Blast is offline  
Page generated in 0.05156 seconds with 7 queries