View Single Post
Old 09-22-2021, 05:41 PM
  #2  
crxmanpat
Community Moderator
 
crxmanpat's Avatar
 
Join Date: Feb 2006
Location: Crawfordville, FL
Posts: 6,966
Default

Welcome to WattFlyer and the world of RC flight!

There are a couple things you can do. First, look at Page 21 of the manual and make sure the wires/clevises are in the proper holes per the Factory Settings for the Control Horns and Servo Arms. If those are correct, the next thing to do is adjust the rudder trim so that the nose wheel is straight. Then remove the clevis from the rudder and turn it in the necessary direction on the threaded rod until the rudder is aligned.
crxmanpat is offline  
 
Page generated in 0.07071 seconds with 10 queries