WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Broken Magnets E-Flite Power 60 & 90
View Single Post
Old 06-09-2014, 05:41 PM
  #27  
Wildflyer
Past President of PSSF
 
Wildflyer's Avatar
 
Join Date: Sep 2009
Location: Lacey WA, 1 mile E of Mushroom Corner
Posts: 2,080
Default

I figure after 62 years of woodworking (started when I was 4 yo) and 40 years of being a carpenter, I have at least inhaled an 8'- 4"x 4".

Somehow it seems I got rid of it, a little at a time, just like it came in.

Carpenters are too stupid or proud, to wear a breathing respirator any time, we or someone close to us are cutting wood. Dry wood dust is the worst as it will stay in the air for over an hour. I have seen this in my own shop.

The cup type paper masks are basically useless, unless you duct tape them to your face. WAY too much leakage around the edges. There are some good ones but they are hard to find.

My idea to cut a magnet is to clamp it between 2 strips of wood and then use my wet diamond saw to trim the edge. I have not tried this yet but I think it would work.
Wildflyer is offline  
 
Page generated in 0.04395 seconds with 8 queries