WattFlyer RC Electric Flight Forums - Discuss radio control eflight - Search Results

 
Search: Posts Made By: meegosh
Showing results 1 to 30 of 111
Search took 0.01 seconds.
03-02-2009, 04:58 PM
Replies: 2,263
Views: 338,998
Posted By meegosh

Hey Gil, sorry to hear about your house. Hope...

Hey Gil, sorry to hear about your house. Hope everyone is ok!

I see the Air Hogs at Walmart and Toys R Us all the time.

You can buy them online at toysrus.com... just search for Air Hogs...
02-25-2009, 07:34 PM
Replies: 2,263
Views: 338,998
Posted By meegosh

Holy cow!!!! 2,000+ posts over three years. Did...

Holy cow!!!! 2,000+ posts over three years. Did not realize I would be starting a cult following when I posted this years ago. I have not been around in quite some time but I still fly occasionally. ...
Forum: Beginners
04-19-2006, 06:01 PM
Replies: 3
Views: 1,400
Posted By meegosh

Thanks for the link, I'll def. bookmark that one....

Thanks for the link, I'll def. bookmark that one. Seems like they have tons. Thankfully my LHS had the ones I needed, granted they were Traxxas :cool:
Forum: Beginners
04-18-2006, 06:57 PM
Replies: 11
Views: 1,942
Posted By meegosh

I'm too sure, maybe some more info on your setup...

I'm too sure, maybe some more info on your setup would be helpful. There are temp guns that I believe are mainly for Nitro models but it would still tell you the temp if you are concerned.

What...
Forum: Beginners
04-18-2006, 02:58 PM
Replies: 3
Views: 1,400
Posted By meegosh

I have figured it out... I got the 4x7x2.5...

I have figured it out... I got the 4x7x2.5 bearing and it works fine. I also just drilled out the props and prop saver so I'm all set to go again. Hopefully my first flight on my first pack will go...
Forum: Beginners
04-17-2006, 08:59 PM
Replies: 3
Views: 1,400
Posted By meegosh

Ball bearing question

Hey everyone,

I have been working on fixing my S/S up for another attempt at a maiden flight. I have replaced the drive shaft with a new one but I broke one of the bearings. None of the LHS have a...
04-14-2006, 02:47 PM
Replies: 18
Views: 1,848
Posted By meegosh

I just got my Aiptek 1.3 SD in the mail...

I just got my Aiptek 1.3 SD in the mail yesterday. Got the switch programmed and its all working. Stopping by staples after work to get a 256MB SD card... maybe I'll be able to enter one of these :)...
Forum: Beginners
04-13-2006, 08:50 PM
Replies: 5
Views: 2,297
Posted By meegosh

That's what I was thinking also... I'm going to...

That's what I was thinking also... I'm going to give it one last try, completely take out the drive shaft and put it in the vice again. If that doesn't straighten it enough, I have 3 - 4mm drive...
Forum: Beginners
04-13-2006, 05:07 PM
Replies: 5
Views: 2,297
Posted By meegosh

I'm not sure how practical a dual setup on a SS...

I'm not sure how practical a dual setup on a SS is either but I bought it that way. As far as the prop shaft, should I just try using it as is, with a little (I mean slight) arch in the middle or...
Forum: Beginners
04-13-2006, 02:32 PM
Replies: 5
Views: 2,297
Posted By meegosh

Prop and prop shaft question

I have a SS with dual 350-C motors on it. I had two EP-1365 props that came with it and all was fine untill I broke those two. I ordered 5 props, 4 of the 1365's and a 1390, none of them fit on the...
Forum: Beginners
04-12-2006, 09:09 PM
Replies: 8
Views: 1,280
Posted By meegosh

Let me know how it works out for you, I just bent...

Let me know how it works out for you, I just bent mine a little bit. I'm going to try bending it in place first since its not damaged that bad.

Let me know how it goes, I may be in the same...
Forum: Beginners
04-12-2006, 09:06 PM
Replies: 26
Views: 2,566
Posted By meegosh

Thanks for the input guys, I will just try...

Thanks for the input guys, I will just try carefully bending it back into place. It is only bent up a couple hairs. No major bends in it like its gonna break. Just looks like someone gently squeezed...
Forum: Beginners
04-12-2006, 03:42 PM
Replies: 26
Views: 2,566
Posted By meegosh

Got my props in the mail today, just a little bit...

Got my props in the mail today, just a little bit ago actually. Seems like the nice spring weather is going to keep flights grounded till Saturday it seems.

I took a closer look at my SS the...
Forum: Beginners
04-11-2006, 04:15 PM
Replies: 26
Views: 2,566
Posted By meegosh

Thanks for the kind words TinLid, next time out I...

Thanks for the kind words TinLid, next time out I will be extremely careful and just watch it climb rather than giving any inputs at all. Once it gets up a little I will try just tapping the up...
Forum: Beginners
04-11-2006, 02:39 PM
Replies: 26
Views: 2,566
Posted By meegosh

Thanks Doc & what_the for your feedback. I want...

Thanks Doc & what_the for your feedback. I want to use everyone's input but I'm stuck playing the waiting game on the props. They shipped yesterday so hopefully they'll be here tomorrow.

I just...
Forum: Beginners
04-10-2006, 11:40 PM
Replies: 26
Views: 2,566
Posted By meegosh

Thanks for all the input guys, I spent all day on...

Thanks for all the input guys, I spent all day on the sim again, since I'm stuck waiting for props. I will attempt to decrease the throttle a little once it gets up in the air and see if that lets...
Forum: Beginners
04-10-2006, 08:16 PM
Replies: 26
Views: 2,566
Posted By meegosh

Thanks guys for the encouragement. Like everyone...

Thanks guys for the encouragement. Like everyone else said, ROG = Rise off ground/grass. I think I will try another ROG and attempt to get it up to altittude so that I can adjust the trims and...
Forum: Beginners
04-10-2006, 07:35 PM
Replies: 26
Views: 2,566
Posted By meegosh

I was thinking about the over control also but I...

I was thinking about the over control also but I did remember not to over control the plane. That is one of the things I was focusing on. I barely, I mean barely tapped the up elevator. I think it...
Forum: Beginners
04-10-2006, 04:26 PM
Replies: 26
Views: 2,566
Posted By meegosh

Unhappy Unsucessful maiden voyage

I have finally got everything on my plane straightened out. Modded the landing gear with a coat hanger so that it gives a little more support. Then I zip tied the landing gear on because the part it...
04-07-2006, 06:04 PM
Replies: 6
Views: 2,748
Posted By meegosh

Hey Steve, Thanks for the reply, I know it...

Hey Steve,

Thanks for the reply, I know it will hold a couple AP flights on one card but I was thinking more about just leaving it on, flying for a month, snapping shots all the time and then...
04-06-2006, 05:34 PM
Replies: 13
Views: 1,954
Posted By meegosh

Great videos sxates! Seems like your plane has a...

Great videos sxates! Seems like your plane has a curb sensing nose on it!! :) Who needs breaks when you can just use curbs, right?!

Haha, great videos, quite insprining. Keep up the good work man!
04-06-2006, 04:42 PM
Replies: 6
Views: 2,748
Posted By meegosh

Aiptek SD 1.3 Question

I am going to buying a Pencam 1.3 (sd version) from Etronic on RCG. He is assembling them with a switch for $60 shipped. I am going to be buying one hopefully today.

I have a question about the...
04-06-2006, 04:38 PM
Replies: 4
Views: 1,398
Posted By meegosh

Great photos guys, and Steve, I am so excited to...

Great photos guys, and Steve, I am so excited to get my pencam. Hopefully it'll be here within a week or two. Seems like for the price, you can't beat the SD 1.3 PenCam.

Keep up the good work guys!
04-06-2006, 04:23 PM
Replies: 27
Views: 4,065
Posted By meegosh

I haven't begun to take APs but I am buying a...

I haven't begun to take APs but I am buying a PenCam 1.3SD and going to try my luck. Even though I am not a true AP'er (yet), I still love coming to these forums and looking at all the amazing shots!...
04-05-2006, 08:58 PM
Replies: 60
Views: 11,201
Posted By meegosh

I'm wondering the same about irc.. I am...

I'm wondering the same about irc.. I am constantly on irc so I could definatly stop by more often! I spent the last 15 minutes looking over each little link on the site, only to read Marc's post...
Forum: Combat
04-04-2006, 05:32 PM
Replies: 28
Views: 17,032
Posted By meegosh

I was inquiring about this quite some time ago....

I was inquiring about this quite some time ago. From what Debhicks was saying, AirWars seems pretty neat. It seems a little expensive but think of it this way, if you were doing full combat, that...
04-03-2006, 08:11 PM
Replies: 2,263
Views: 338,998
Posted By meegosh

Go to walmart's fishing department. Look for a...

Go to walmart's fishing department. Look for a little bag with glow sticks in them. They are meant to clip onto bobbers so that you can see your bobber at night.

They come with like six sticks...
04-03-2006, 08:02 PM
Replies: 2,263
Views: 338,998
Posted By meegosh

I've been away from wattflyer for quite some...

I've been away from wattflyer for quite some time. I'm glad to see that this thread is still getting the attention it deserves!

Since the couple months I have not posted on here, I now own 3 and...
01-25-2006, 05:24 PM
Replies: 28
Views: 10,586
Posted By meegosh

Thanks for the heads up, I was gonna buy one and...

Thanks for the heads up, I was gonna buy one and just try it but I'll save the gas money. Any idea when the "real" jet is supposed to come out?
01-23-2006, 08:26 PM
Replies: 28
Views: 10,586
Posted By meegosh

I'd say just buy it and try it out and let us...

I'd say just buy it and try it out and let us know what you think of it! You can always return it if it doesn't fly so that shouldn't be a worry. They won't stick you with a plane that doesn't fly.
...
Showing results 1 to 30 of 111
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.04637 seconds with 7 queries