WattFlyer RC Electric Flight Forums - Discuss radio control eflight - Search Results

 
Search: Posts Made By: Westwind
Showing results 1 to 30 of 33
Search took 0.00 seconds.
08-14-2013, 06:41 PM
Replies: 1
Views: 1,105
Posted By Westwind

Re: DX6I With 3 Recivers

Sold


Sent from my SGH-I337M using Tapatalk 4
05-10-2013, 01:34 AM
Replies: 1
Views: 1,105
Posted By Westwind

DX6I With 3 Recivers

Please see my ebay listing for details

http://cgi.ebay.ca/ws/eBayISAPI.dll?ViewItem&item=321123146690#

I may trade for aircraft

Thanks,
Nathan
04-15-2013, 12:45 PM
Replies: 0
Views: 811
Posted By Westwind

DX6i, carry case, 3 receivers v

I'm selling the following radio gear

DX6i transmitter SPM6610
http://www.horizonhobby.com/products/dx6i-dsmx-6-channel-full-range-without-servo-md2-SPM6610
Plus soft carry case
$155.00

6...
03-13-2013, 11:48 AM
Replies: 16
Views: 2,038
Posted By Westwind

Quick question

I want to increase my run time by using two batteries, can't remember if I need to connect them in parallel or series?

Sent from my GT-I9000 using Tapatalk 2
03-05-2013, 02:16 PM
Replies: 2
Views: 1,874
Posted By Westwind

P-61

Help, I'm looking for a P-61 kit, do you guys know of any?

Sent from my GT-I9000 using Tapatalk 2
02-25-2013, 03:16 AM
Replies: 27
Views: 15,418
Posted By Westwind

Hi guys I'm still a noob, only been flying for a...

Hi guys I'm still a noob, only been flying for a few months. I would like to put a telemetry set on my Radian Pro and Fun Cub and was thinking of the FrSky system. I run Spektrum gear with a DX6i tx....
Forum: Beginners
02-13-2013, 04:27 AM
Replies: 7
Views: 1,356
Posted By Westwind

Once again guys thanks for you input. I realized...

Once again guys thanks for you input. I realized that if i used a lipo i would probably run it down below 3v per cell by accedent so what i did was hook up a 1200 mah nimh batt at it wooks great.
Forum: Beginners
02-13-2013, 01:22 AM
Replies: 1
Views: 565
Posted By Westwind

Rx data port

Other then binding, what can I do with the data port on my spektrum recivers?

Sent from my GT-I9000 using Tapatalk 2
Forum: ParkFlyers
02-12-2013, 12:14 PM
Replies: 12
Views: 7,671
Posted By Westwind

Fun Cub Gear Improvements

So everyone knows the Fun Cub is an awesome plane, but the gear... not so much. I would like to know what people have done to improve the gear.

Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
02-11-2013, 04:32 PM
Replies: 7
Views: 899
Posted By Westwind

Re: Thanks all

http://img.tapatalk.com/d/13/02/12/avebumuq.jpg
http://img.tapatalk.com/d/13/02/12/ynu3y6eb.jpg
Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
02-11-2013, 04:29 PM
Replies: 7
Views: 899
Posted By Westwind

Thanks all

So I have completed my fun cub and have over an hour flying it. I want to thank you guys fire the advise given. Here is a pic


Sent from my GT-I9000 using Tapatalk 2
01-27-2013, 08:11 PM
Replies: 3
Views: 902
Posted By Westwind

It works, but the run time is short and replacing...

It works, but the run time is short and replacing 9v will get expensive. this is a link to the lipo I have....
01-27-2013, 07:15 PM
Replies: 3
Views: 902
Posted By Westwind

9 volt or lipo

I have Ram 15, 04, and 16 light systems. I have spliced them together and run the system of a 9 volt battery. I would like to try ruining them off a turnigy nano-tech 370mah 25-40C battery. Ram says...
01-27-2013, 04:28 PM
Replies: 33
Views: 8,911
Posted By Westwind

Re: FREE giveaway from MaxAmps.com - post in this thread to enter

Nice hoddie

Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
01-27-2013, 12:15 AM
Replies: 7
Views: 1,356
Posted By Westwind

Batteries for light system

I have Ram 15, 04, and 16 light systems. I have spliced them together and run the system of a 9 volt battery. I would like to try ruining them off a turnigy nano-tech 370mah 25-40C battery. Ram says...
Forum: Beginners
01-27-2013, 12:03 AM
Replies: 6
Views: 974
Posted By Westwind

Re: Reciver placement

I have a 9 volt battey on the flour just infront of the hole in the bottom to run my lights. I'm using a spectrum ar600. Did not want the reciver there as I will be fling of the water in the summer...
Forum: Beginners
01-26-2013, 01:26 PM
Replies: 6
Views: 974
Posted By Westwind

Reciver placement

Almost completed my fun cub build and I have a question about the reciver placment. I have it mounted inside the plane on the wall near the battery door, with the antenna going out the door and along...
Forum: Beginners
01-24-2013, 02:35 AM
Replies: 19
Views: 2,582
Posted By Westwind

Re: Chartering servo???

I did not disconnect the servo as I just completed the rigging, but of I put the slightest amount if up pressure on it the chattering stops so I think out would not happen in the air.

Thanks for...
Forum: Beginners
01-23-2013, 06:31 PM
Replies: 19
Views: 2,582
Posted By Westwind

Re: Chartering servo???

I'll check the servo a you direct

Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
01-23-2013, 06:29 PM
Replies: 19
Views: 2,582
Posted By Westwind

Re: Chartering servo???

Got my prop off, but thanks for the warning

Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
01-23-2013, 05:34 PM
Replies: 19
Views: 2,582
Posted By Westwind

Re: Chartering servo???

Have to check when I get home

Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
01-23-2013, 04:58 PM
Replies: 19
Views: 2,582
Posted By Westwind

Re: Chartering servo???

It's a buzzing, flap dosen't move. It happens when the system is at rest. The flap seems to move freely

Sent from my GT-I9000 using Tapatalk 2
01-23-2013, 03:33 PM
Replies: 30
Views: 10,351
Posted By Westwind

Re: dx6i flaps

I have a dx6i with an AR600 on the fun cub. Still in build mode but I got the flaps working in three positions 0, about 40 and about 80. I put one servo on the gear ch and another on the aux ch...
Forum: Beginners
01-23-2013, 10:06 AM
Replies: 19
Views: 2,582
Posted By Westwind

Chartering servo???

I'm setting up my fun cub and have found one of my flap servos is chattering. I have one servo on the gear ch and another on the aux ch. Ther one on the gear is chartering. I can trim it through my...
Forum: Power Systems
01-19-2013, 06:31 PM
Replies: 3
Views: 854
Posted By Westwind

Re: Faulty ESC

Thanks for the advise

Sent from my GT-I9000 using Tapatalk 2
Forum: Power Systems
01-19-2013, 04:14 AM
Replies: 3
Views: 854
Posted By Westwind

Faulty ESC

So I had a crash e with my fun cub. Broke the blades, and the motor stalls. It tries to turn buy just kinda wiggles and makes a screeching noise. I plugged it into my heli ESC abd it works fine. So...
Forum: Beginners
01-17-2013, 12:42 PM
Replies: 33
Views: 4,898
Posted By Westwind

Re: Is this too much? Battery question

Sorry 35 C

Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
01-17-2013, 12:41 PM
Replies: 33
Views: 4,898
Posted By Westwind

Re: Is this too much? Battery question

The pack is rated at 3d C

Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
01-11-2013, 08:36 PM
Replies: 6
Views: 1,015
Posted By Westwind

Re: Servo issue

Thanks guys, I'll try the sub trim

Sent from my GT-I9000 using Tapatalk 2
Forum: Beginners
01-11-2013, 06:57 PM
Replies: 6
Views: 1,015
Posted By Westwind

Re: Servo issue

Tried that nil fix

Sent from my GT-I9000 using Tapatalk 2
Showing results 1 to 30 of 33
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.06067 seconds with 7 queries