Search: Posts Made By: Mikec
Showing results 1 to 10 of 10
Search took 0.00 seconds.
11-05-2016, 09:44 PM
Replies: 4
Views: 7,397
Posted By Mikec

porposing problem on eflite blade cp

I have just encountered this problem on my old cp. I have replaced servos, reciever, checked mainshaft, and balance,but after flying for 5 minutes or more it starts porposing so severly i have to...
02-13-2014, 05:55 PM
Replies: 5
Views: 3,510
Posted By Mikec

I take it that its sold?

I take it that its sold?
08-12-2006, 02:32 AM
Replies: 7
Views: 2,471
Posted By Mikec

What I meant by correct washer stack-up was to...

What I meant by correct washer stack-up was to use two washers under the head of the allenhead screw that secures the blade grip to the feathering shaft. Put a 3mm washer (that is the size used as...
07-20-2006, 08:44 PM
Replies: 2
Views: 1,226
Posted By Mikec

Thanks for the reply. After systematically...

Thanks for the reply. After systematically checking out everything for the second time I decided to try replacing the tail motor and believe it or not that solved my problem. No matter how much you...
07-18-2006, 03:04 PM
Replies: 2
Views: 1,226
Posted By Mikec

New problems with my cp blade

I have had my cp since christmas and have been practicing on and off since than. I thought that I had encountered most problems and so far have corrected them, as this is a constant learning...
06-03-2006, 01:06 AM
Replies: 7
Views: 2,471
Posted By Mikec

I removed the blade grips and reinstalled with...

I removed the blade grips and reinstalled with correct washer stack-up and after two hover sessions no more jumping (yo yo) Thanks for the hint. On the negative side while practicing inside my garage...
05-31-2006, 01:56 AM
Replies: 7
Views: 2,471
Posted By Mikec

I am flying both inside and out. This problem...

I am flying both inside and out. This problem just showed up recently while flying outside with little or no wind. I am going to take the grips off and check the washer stckup and give that a try.
05-29-2006, 08:22 PM
Replies: 7
Views: 2,471
Posted By Mikec

e-flite cp blade

I will check it out and let you know what I found. I will not be flying again until next weekend.
05-29-2006, 07:14 PM
Replies: 7
Views: 2,471
Posted By Mikec

E-Flite CP Blade

I have had a blade since christmas. I have been practicing with it on and off encountering all the problems of flying electric helicopters. My curreent problem is after hovering about a couple of...
12-24-2005, 07:30 PM
Replies: 5,460
Views: 856,859
Posted By Mikec

I am new to electric helicopter flying. I just...

I am new to electric helicopter flying. I just recently purchased a E-Flite CP blade and I am in the learning process of hovering. Have had a few crashes but I have also bought a E-SKY simulator and...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.04122 seconds with 7 queries