WattFlyer RC Electric Flight Forums - Discuss radio control eflight

WattFlyer RC Electric Flight Forums - Discuss radio control eflight (https://www.wattflyer.com/forums/index.php)
-   E-Flite Helicopters (https://www.wattflyer.com/forums/forumdisplay.php?f=103)
-   -   Having problems with my new blade cx2 heli (https://www.wattflyer.com/forums/showthread.php?t=42152)

cbflight92 12-27-2008 06:10 PM

Having problems with my new blade cx2 heli
 
I have just bought the aluminum lower rotor head for my blade cx2 and i can figure out how to put it on, i can not get the shaft out to put it on or anything so please would somebody inform me how to do this or give me a link

theecoop 12-27-2008 06:37 PM

look here. http://www.dacaur.com/heli/bcxhelp/BladeCXAssembly.pdf

schreydog 01-12-2009 04:33 PM

aluminum rotor
 
you don't have to remove the shaft, just loosen the two set screws on the bottom gear and pull the inner shaft. remove bearing on top,separate the linkage from the swashplate. loosen the four screws on the old rotor and it will slide off. sometimes you have to get sandpaper to remove burrs. when you put the new one on, do the top screws first as they must line up with the two holes you'll see on the outer shaft. also fyi, if you ever do pull the outer shaft, there is a brass step washer on top of the gear, keep track of this asit won't fly without it. schreydog


All times are GMT +1. The time now is 07:53 AM.

Powered by: vBulletin
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.07521 seconds with 10 queries