WattFlyer RC Electric Flight Forums - Discuss radio control eflight

WattFlyer RC Electric Flight Forums - Discuss radio control eflight (https://www.wattflyer.com/forums/index.php)
-   Electric Ducted Fan Jets (https://www.wattflyer.com/forums/forumdisplay.php?f=12)
-   -   castle bec in Viper (https://www.wattflyer.com/forums/showthread.php?t=80972)

jangodog 09-01-2020 04:55 PM

castle bec in Viper
 

Castle bec in Viper

Aug 26, 2020, 06:07 AM
Hello. How do i install the Castle bec 10amp in the Eflite Viper? Under the belly beside the esc and do i need any accessories?

crxmanpat 09-01-2020 05:38 PM

1 Attachment(s)
There is no specific place the Castle UBEC needs to be installed, but you do want it where it will get a little air cooling.

You will need to solder the power leads of the BEC into the battery connection. I think this comes with an EC5 connector, and the pins can be pushed out of the housing (they just snap in). Push the pins out and solder the BEC power leads to them (see example in the pic, the green circuit board is the BEC in this case). You will also need to pull the red wire from the ESC lead to the RX. Take a hobby knife and gently insert under the locking tab in the connector and lift up, then pull the red wire out and secure it with tape. The Castle RX lead then plugs into the RX in the battery/bind port depending on your RX.

jangodog 09-01-2020 07:40 PM

Great my friend. Finally someone took the time to help me on this bec issue:)
I won't connect an extra battery though to the bec just the main lipo.

Thank's.


All times are GMT +1. The time now is 05:11 PM.

Powered by: vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.03778 seconds with 7 queries