WattFlyer RC Electric Flight Forums - Discuss radio control eflight

WattFlyer RC Electric Flight Forums - Discuss radio control eflight (https://www.wattflyer.com/forums/index.php)
-   Special Interest Aircraft (https://www.wattflyer.com/forums/forumdisplay.php?f=214)
-   -   Nostalgia-Mambo with Tobe Galloping Ghost (https://www.wattflyer.com/forums/showthread.php?t=78012)

E-Challenged 10-24-2016 11:21 PM

Nostalgia-Mambo with Tobe Galloping Ghost
 
Just want to share. I obtained a Tobe GG motor driven actuator that works with ANY modern proportional RC transmitter and receiver to give you flapping proportional rudder and elevator control plus normal throttle control via the speed control when using electric power. The actuator with attached "recoder" plugs into the aileron and elevator channels of any modern receiver on any frequency with no modifications to transmitter or receiver.

Contact Jay Mendoza , Mission Viejo, CA for info and pricing on the Tobe actuator:

[email protected]

I downloaded the plans for a 1960's 48" wingspan Mambo trainer from Outerzone to a flashdrive and took it to a FedEx Central office where they printed full size plan and pattern sheets plus the original Mambo wing logo for $16. I found a good local hobby shop, Remote Control Hobbies, in Orange, CA where they keep a good stock of sheet balsa, ply and basswood
as well as bagged accessory items and wheels.(About $76)

I'm ready to start cutting out ribs, formers and balsa sheet slab fuselage parts. Covering will be translucent red for wings and lifting stab and yellow for he fat fuselage. Graphics will be by Callie Graphics.

Nostalgia doesn't come cheap but should be a lot of fun.:D

E-Challenged 11-06-2018 06:55 PM

Update

The little Tobe GG actuator did not have enough power to control my full size Mambo, better suited to smaller Mini Mambo and other smaller lighter models. I installed two 9 gm servos and the model is now fully controllable. Watch Otto Diffenbach's videos on You Tube.:)

Abuelo 12-30-2018 03:31 AM

Galloping Ghost
 

Originally Posted by E-Challenged (Post 1015589)
Update

The little Tobe GG actuator did not have enough power to control my full size Mambo, better suited to smaller Mini Mambo and other smaller lighter models. I installed two 9 gm servos and the model is now fully controllable. Watch Otto Diffenbach's videos on You Tube.:)

Thanks for the update. I also have the Tobe GG actuator and I'm debating on either the Half Tone by Dave Platt or the RCM 1/2A Basic Trainer by Dick Tichenor. Both would have been .049 powered and rudder and elevator back when designed. I have the plans for each and probably most of the wood and covering, just need to get a project out of the way and flying before deciding.

I'll post once I get to building. I really wanted a GG setup back in the 1960s but didn't have the money. Now is the time to relive my youth the way I wanted to.


All times are GMT +1. The time now is 01:18 AM.

Powered by: vBulletin
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.08148 seconds with 9 queries