Dr Kiwi Dr Kiwi is offline

Super Contributor

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 02-09-2014 05:19 AM
  • Join Date: 08-18-2005
  • Referrals: 0

Friends

Showing Friends 1 to 3 of 3

Visitor Messages

Showing Visitor Messages 1 to 7 of 7
  1. 08-19-2010 02:27 PM
  2. mred
    08-17-2010 04:41 PM
    Greetings;
    Any chance I can get your e-mail address? I have a question that is kind of long and has some trouble shooting in it that I have done. I tried, but it said it was to long for a PM.
    Thanks

    Ed
  3. 11-11-2009 04:23 PM
    JIMO... I have used carbon fiber rods... I can't think of what size is suitable of the top of my head, but you can get CF rod in lots of sizes in 3ft/4ft lengths.

    Cheers, Phil
  4. 11-11-2009 09:26 AM
    Hi doc, I Need some help,i have look every were for servo rods, for foam rc planes, 65mm,would know where i can buy them,
    hope you can help,
    kind regards
    jim
  5. 11-08-2009 08:05 PM
    Dr kiwi
    question from ch ch nz--can i extend esc leads to outruner by a few inches---60amp esc.
    Thanks
    tom
  6. CHELLIE
    03-13-2009 06:04 AM
    How did you escape my friends List :) take care and have fun, Chellie
  7. watt_the?!
    10-12-2008 10:33 PM
    hi Dr. K. i wonder if you can assist me in doing an experiment to support my high voltage/low voltage argument?. i figure that you have all the gear and so could easily do a controlled and measured, structured experiment to verify/debunk the theory.
    all it needs is some high v setups and corresponding ESCs.

    the key is that each setup needs to draw the same relative C load from the batteries AND the ESC.

    i.e. if a setup is drawing 10C on a 1000mah pack and a 10A ESC then a comparison setup might be 25A on a 2500mah pack and a 25A ESC.

    the motors need to run in similar ranges also.

    please let me know if you're interested.

    cheers mate,

    tim

iTrader

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.07812 seconds with 27 queries