jrb jrb is offline

Member

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 12-03-2008 04:38 PM
  • Join Date: 07-29-2005
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. 08-05-2008 08:00 PM
    jrb
    Been traveling; sorry for not seing this earlier Peter.

    Good question for post; lost will learn from the responses.

    Depends a bit your battery connector.

    With Deans you need a harness (make or buy).

    With Sermos/Aderson Power Pole you can split to red and black from one pack and make a series connection.

    BOL!

    Jim
  2. PetesCub
    07-30-2008 08:17 PM
    Hi JRB,

    I noticed you have a 1/5 Cub. I have completed a 1/5 Anniversary SIG Cub and I'm going electric. I have a 4120/20 AXI brushless and a JETI 70 Opto plus ESC (No BEC). I have ordered 2 Zippy 4800Mah 3S 20C Lipo's which are on the way. My question to you is this. What will I need to connect these batteries in series, and then to the ESC? I'd like also to add a BEC if possible. I was hoping you may have some advice about how to best go about setting this up, be Dean's Ultr or bullets etc. Any advice would be muh appreciated.

    Best,
    Peter

iTrader

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.06724 seconds with 24 queries