WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Profile: southdakotarcflyer

southdakotarcflyer southdakotarcflyer is offline

New Member

Visitor Messages

Showing Visitor Messages 1 to 3 of 3
    04-12-2011 06:34 AM
    Hi, on the P 38 , I think that the BEC was not disconnected on the ESC, if the ESC have a BEC and they fought each other, and burned up, if your esc have a bec, disconnect both of them, its normally the red wire on the small plug that goes to the receiver, you just need to use a pin and lift the lock on the wire terminal, and pull the wire out, and tape it up, Then use a seperate UBEC, from Castle Creation, its a 10 amp UBEC, and you will need that for all the big servos, and if your using 2.4, hope that helps, Chellie


  2. southdakotarcflyer
    10-24-2010 04:40 PM
    I live in Edgemont south west corner . I spent last winter in Ariz. with a trainer I fly a Nextstar and a SC and a couple of blue foam planes that I have built from plans that have been passed down from members of the club in Ariz. I and another guy here have been trying to get people interested in flying so we can form a club. So far its not working. Larry
  3. cjg
    10-24-2010 04:13 AM
    I live in Vermillion, where are you located in South Dakota.

    I taught myself to fly with a blade CX and a supercub.

About Me

  • About southdakotarcflyer
    Retired Rail Road Conductor, Married with 4 kids all gone now. So I have time to fly
    South West Corner of South Dakota
    I just got back into RC flying after 35 years, Also Ride a Harley, Like to spend time with friends
    Favorite Pet(s)
    Two Barkie Von Schnauser's
    East Valley Flyers APJ Ariz in winter


Total Posts
Visitor Messages
General Information
  • Last Activity: 04-12-2011 06:03 PM
  • Join Date: 09-23-2010
  • Referrals: 0


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.07473 seconds with 23 queries